[CQ-Contest] N1MM Software - FT-1000 communication

[rin JG1VGX]

I once overheard that, for CAT to work properly, FT-1000's ROM needs
to be updated to version 6. Not sure if this applies to your case.

http://www.hb9bnk.ch/index.php?id=17&L=1
http://www.eham.net/ehamforum/smf/index.php?topic=33831.0;wap2
http://www.ebay.com/itm/FT-1000-and-FT-1000D-Rom-6-0-Upgrade-/261051231953

73 rin JG1VGX

On Sat, Nov 22, 2014 at 3:00 AM, FritzOAQ <fritz at k4oaq.com> wrote:
> I'm trying to get my station back on the air after about 10yrs of
> inactivity. Back then I used CT software, FT-1000 & the FIF-232C black box.
> The connection between the black box & computer was via a RS232 25-pin
> connector. It worked fine for a while but then CT stopped getting the freq
> from the FT-1000. I never did try to figure out the problem. So, the first
> question is whether the FIF-232C can be connected to N1mm software? I'm new
> to N1MM software but it appears to me that one can only communicate with it
> via USB "COM ports". If there's no way to use the FIF-232C box, then I can
> forget trying to figure out whether it is defective & buy a new black box
> that takes the FT-1000 to a USB "COM port". Any recommendations for this box
> wud be appreciated.
>
> Fritz K4OAQ
>
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest at contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest



-- 
73 de rin JG1VGX