[CQ-Contest] N1MM Software - FT-1000 communication

[Barry]

If it worked with CT, it has the updated ROM.
Barry W2UP

On 11/21/2014 18:31, rin JG1VGX wrote:
> I once overheard that, for CAT to work properly, FT-1000's ROM needs
> to be updated to version 6. Not sure if this applies to your case.
>
> http://www.hb9bnk.ch/index.php?id=17&L=1
> http://www.eham.net/ehamforum/smf/index.php?topic=33831.0;wap2
> http://www.ebay.com/itm/FT-1000-and-FT-1000D-Rom-6-0-Upgrade-/261051231953
>
> 73 rin JG1VGX
>
> On Sat, Nov 22, 2014 at 3:00 AM, FritzOAQ <fritz at k4oaq.com> wrote:
>> I'm trying to get my station back on the air after about 10yrs of
>> inactivity. Back then I used CT software, FT-1000 & the FIF-232C black box.
>> The connection between the black box & computer was via a RS232 25-pin
>> connector. It worked fine for a while but then CT stopped getting the freq
>> from the FT-1000. I never did try to figure out the problem. So, the first
>> question is whether the FIF-232C can be connected to N1mm software? I'm new
>> to N1MM software but it appears to me that one can only communicate with it
>> via USB "COM ports". If there's no way to use the FIF-232C box, then I can
>> forget trying to figure out whether it is defective & buy a new black box
>> that takes the FT-1000 to a USB "COM port". Any recommendations for this box
>> wud be appreciated.
>>
>> Fritz K4OAQ
>>
>> _______________________________________________
>> CQ-Contest mailing list
>> CQ-Contest at contesting.com
>> http://lists.contesting.com/mailman/listinfo/cq-contest
>
>