[ct-user] ansi.sys

[David Robbins]

ansi.sys gets loaded in your config.sys when you start the pc.  i use
the line 

devicehigh=\dos\ansi.sys
or
device=\dos\ansi.sys

in the config.sys to load it.  

Richard L. King wrote:
> 
> I have seen this queston asked before but I have never seen a public answer.
> 
> When I start CT using VGA mode, I have a problem when I exit the program.
> The PC screen stays in VGA mode and only uses half the screen. I also get a
> message that says something to the effect, "ANSI.SYS needs to be
> installed". I have to re-boot the PC to get back to normal monitor mode.
> 
> I have the ANSI.SYS program, so the presence of that file isn't enough to
> fix this. I must need to do something more?
> 
> I am running a 386-SX and CT 9.39.
> 
> Thanks.
> 
> 73, Richard
> 
> k5na@texas.net
> 
> --
> Submissions:              ct-user@contesting.com
> Administrative requests:  ct-user-REQUEST@contesting.com
> WWW:                      http://www.contesting.com/ct/
> Questions:                owner-ct-user@contesting.com

-- 
David Robbins K1TTT (ex KY1H)
k1ttt@berkshire.net   or   robbins@berkshire.net
http://www.berkshire.net/~robbins/k1ttt.html

--
Submissions:              ct-user@contesting.com
Administrative requests:  ct-user-REQUEST@contesting.com
WWW:                      http://www.contesting.com/ct/
Questions:                owner-ct-user@contesting.com