[ct-user] MFJ tnc problem

[Jim Reisert AD1C]

The baud rate setting of the TSR *DOES NOT MATTER* - EVER.  I wish Ken 
would remove this parameter.

The only place the baud rate matters is inside CT in the COM port setup.

- Jim

At 10:22 AM 11/17/00 -0500, John Scott wrote:

>You do not state what model of MFJ TNC you're using.  I have a MFJ-1270C
>with firmware release level 2, version 2.0  release 2.2 dated 11/11/95
>that works just fine.
>I note in your note you've designated 4800 bits per second via the TSR.
>I presume that the dip switches on the TNC are set the same.  If your
>serial port will support it, I would suggest setting the TNC for 9600
>and set the TSR for the same.


--
Jim Reisert AD1C <jjreisert@alum.mit.edu>
http://www.ad1c.com/


--
WWW:                      http://www.k1ea.com/
Submissions:              ct-user@contesting.com
Administrative requests:  ct-user-REQUEST@contesting.com
Problems:                 owner-ct-user@contesting.com