[ct-user] FT1000(not D or MP) rig interface problem

[n5nj@gte.net]

It sounds like you may either have a problem with this interface thing, or you may have the radio in a mode that CT can't read.

If for example, you are in a tune-able memory mode of operation, you're not using a VFO which is what CT is looking for.

Make sure you're on VFO A or B.

Since you can't get this to work with any software, I'd suspect that the problem is in the radio or the interface.

73,
Bob N5NJ

Original Message:
-----------------
From: Pete Soper psoper@pjs.East.Sun.COM
Date: Mon, 19 Nov 2001 10:40:52 -0500
To: ct-user@contesting.com
Subject: [ct-user] FT1000(not D or MP) rig interface problem


In a guest op setting recently I put my CT 9.65 on the station computer, set up
a comtsr -n82 -b4800 and could not get CT to read the rig info. I could
switch frequencies but nothing valid seemed to be coming back. Attempts to
switch bands with function keys caused a moment change, then reversion to the
original band (I guess CT checks for something coming back and decided to 
undo the command if it isn't forthcoming). 

The DOS environment for both TR and CT appeared to be identical. I hauled my
DOS CT system from home but no luck. I tried CT 9.57: no change. I did a lot
of downright superstitious changes and experiments and got the expected results.

The interface is a W1GEE model and between it and the computer's DB9 serial
connector there was  receive/xmit data, ground, and "that signal that is on 
pin 20 on a DB25 computer serial port (DSR or DTR, I can never keep them 
straight)". 

Any clues?

Regards,
Pete AD4L
_______________________________________________
ct-user mailing list
ct-user@contesting.com
ct-user-request@contesting.com Subject=unsubscribe to unsubscribe
http://lists.contesting.com/mailman/listinfo/ct-user

--------------------------------------------------------------------
mail2web - Check your email from the web at
http://mail2web.com/ .