[ct-user] CT 9.90.007 and Paddle

[Bob Schreibmaier]

Oh yes, I know I shouldn't mention the "N" word,
but it works fine with NA.  8^)

----- Original Message -----
From: "Bob Schreibmaier" <k3ph at ptd.net>
To: <k1ep at arrl.net>; <k1ttt at arrl.net>
Cc: <ct-user at contesting.com>
Sent: Thursday, June 26, 2003 8:55 PM
Subject: Re: [ct-user] CT 9.90.007 and Paddle


> Excellent suggestion!  Hate to admit it, but that
> never even occurred to me.  Doh!
>
> Radio turned off, all cables disconnected, same results.
> CT will send a string of dits or string of dahs with
> no problems.  Mix them up and garbage comes out,
> after the first character.
>
> ----- Original Message -----
> From: "Ed Parish K1EP" <k1ep at arrl.net>
> To: "Bob Schreibmaier" <k3ph at ptd.net>; <k1ttt at arrl.net>
> Cc: <ct-user at contesting.com>
> Sent: Thursday, June 26, 2003 8:22 PM
> Subject: Re: [ct-user] CT 9.90.007 and Paddle
>
>
> > Don't even connect it to the radio to test.  Type SOUND to turn on the
PC
> speaker and you will get sidetone from the PC.  That way you can check out
> your computer setup regardless of the radio.
> >
> > >Hi David,
> > >
> > >Thanks for the response.
> > >
> > >This is my first attempt.  Running 5 watts into a dummy load.
> > >Wiring looks good.  Single dits and dahs work okay.  Putting
> > >them together creates garbage, after the initial good first
> > >letter.  Tried Super CMOS, Curtis A, and Curtis B modes with
> > >no difference.  Tried two different paddles with no difference.
> > >
> > >Was thinking about performing an exorcism.  8^)
> > >
> > >73,
> > >Bob
> > >
> > >----- Original Message -----
> > >From: "David Robbins K1TTT" <k1ttt at arrl.net>
> > >To: "reflector ct-user" <ct-user at contesting.com>
> > >Sent: Thursday, June 26, 2003 4:20 PM
> > >Subject: RE: [ct-user] CT 9.90.007 and Paddle
> > >
> > >
> > >> Check that you aren't getting rf into the port... turn off or reduce
> > >> radio power.  Doublecheck wiring and pin numbers, make sure no pins
are
> > >> shorted and that pullup resistors are properly connected.  Slow the
> > >> speed way down and try to send single dits and dahs to see if maybe
you
> > >> have bounce in a paddle contact.  Has it worked with earlier versions
> on
> > >> that machine or is this your first attempt??
> > >>
> > >>
> > >> David Robbins K1TTT
> > >> e-mail: mailto:k1ttt at arrl.net
> > >> web: http://www.k1ttt.net
> > >> AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> > >>
> > >>
> > >> > -----Original Message-----
> > >> > From: ct-user-bounces at contesting.com [mailto:ct-user-
> > >> > bounces at contesting.com] On Behalf Of Bob Schreibmaier
> > >> > Sent: Thursday, June 26, 2003 20:00
> > >> > To: ct-user at contesting.com
> > >> > Subject: [ct-user] CT 9.90.007 and Paddle
> > >> >
> > >> > I tried to use CT 9.90.007 and an external paddle on
> > >> > a Toshiba 486/50 laptop (QRP Field Day computer)
> > >> > running MS-DOS 6.22.  I used the REVPADDLE command
> > >> > to get the left paddle to send dits and the right
> > >> > to send dahs.
> > >> >
> > >> > Sending with the motion necessary to send a "V",
> > >> > the first letter out is a "V", but the next one is an
> > >> > "F", followed by something unintelligible.
> > >> >
> > >> > I've tried not using REVPADDLE, but simply changing
> > >> > the paddle around.  Same results.
> > >> >
> > >> > Has anyone else seen this behavior?  Is it possible
> > >> > to fix?
> > >> >
> > >> > TIA.
> > >> >
> > >> > 73,
> > >> >     ____             /        _____           /
> > >> >    /    )           /        /               /
> > >> >   /____/   ____    /___     (____    ____   /___    /___
> > >> >  /     )  /    )  /    )         )  /      /    )  /
> > >> > /_____/  /____/  /____/    _____/  (____  /    /  /       . . .
> > >> >
> > >> > +---------------------------------------------------+
> > >> > | Bob Schreibmaier K3PH | E-mail: k3ph at ptd.net      |
> > >> > | Kresgeville, PA 18333 | http://home.ptd.net/~k3ph |
> > >> > +---------------------------------------------------+
> > >> >
> > >> > _______________________________________________
> > >> > CT-User mailing list
> > >> > CT-User at contesting.com
> > >> > http://lists.contesting.com/mailman/listinfo/ct-user
> > >>
> > >>
> > >>
> > >> _______________________________________________
> > >> CT-User mailing list
> > >> CT-User at contesting.com
> > >> http://lists.contesting.com/mailman/listinfo/ct-user
> > >>
> > >
> > >_______________________________________________
> > >CT-User mailing list
> > >CT-User at contesting.com
> > >http://lists.contesting.com/mailman/listinfo/ct-user
> >
> >
> > CONFIDENTIALITY NOTICE: This message is a PRIVATE communication. This
> email may
> > contain privileged and confidential information intended only for the
> above-named
> > recipient. If you have received this in error and you are not the
intended
> > recipient, you are hereby notified that any use, dissemination, or
copying
> is
> > strictly prohibited. In such case, do not read, copy, or use it, and do
> not disclose
> > it to others. Please notify the sender of the delivery error by replying
> to this
> > message, and then delete it from your system. Thank you.
> >
> >
> >
> >
>
>
>