[ct-user] CT DOS Comport Configuration Query

[Mike K9MI]

That all folks....

----- Original Message ----- 
From: "Ed K1EP" <k1ep.list at gmail.com>
To: "N6KI Dennis Vernacchia" <n6ki_73 at sbcglobal.net>; 
<ct-user at contesting.com>
Sent: Friday, June 15, 2007 01:49
Subject: Re: [ct-user] CT DOS Comport Configuration Query


> Did you type SETUP after that to let the program know which port the radio 
> was on?
>
> At 6/13/2007 05:05 AM, N6KI Dennis Vernacchia wrote:
>>I have a Celeron machine running WIN98SE
>>I am trying to get set up for a ham friend
>>
>>Problem is it only has 1 COM port on Mother Board
>>
>>I managed to find a NEW 2 COM Port ( 2 DB-9s connectors)
>>PCI board which I installed and the floppy disk that came with it
>>had drivers for DOS and also WIN98
>>
>>I did check the company's web site for any new drivers
>>and the DOS and WIN98 drivers were the same as on the diskette
>>
>>Machine is set to boot into Straight DOS without
>>loading any Windows Driver
>>( set GUI=0 in System.ini file )
>>
>>That works fine, it boots into DOS on turn on
>>
>>I installed the card and DOS driver and I am able to
>>do a port test with a DOS Utility and both COM ports
>>checkout fine.
>>
>>In the CT Directory I load
>>COMTSR1 ( For my Telnet Packet input and that works fine )
>>
>>I am trying to do radio control for a
>>Kenwood TS-950 on one of the new ports on the
>>Plug in serial card
>>
>>I typed
>>
>>COMTSRX -A2E8 -B4800
>>( Where X = 2, 3 and 4 com ports.....to no avail)
>>
>>Any ideas what I am doing wrong
>>
>>The Blue confirmation Window always comes up and verifies that
>>I did in fact get the  desired COM port and the port address
>>
>>( The Serial card booklet instructed me that port addresses
>>are 2E8 and 3E8
>>
>>( N81 for other defaults as usual )
>>
>>I also went intoi WIN 98 and loaded those drivers just to be sure
>>WIN98 sees the ports and all is wel there but I know not
>>to run CT for DOS in WIN98
>>
>>I do NOT want to run CTWIN if I can help it as have
>>had too many problems in the past with Video chipsets etc
>>not working correct with CTWIN )
>>
>>Ant DOS gurus out there with some other solutions ?
>>
>>73, Dennis N6KI
>>Sandy Eggo
>>
>>
>>
>>_______________________________________________
>>CT-User mailing list
>>CT-User at contesting.com
>>http://lists.contesting.com/mailman/listinfo/ct-user
>>CT on the web:  http://www.k1ea.com/
>
> _______________________________________________
> CT-User mailing list
> CT-User at contesting.com
> http://lists.contesting.com/mailman/listinfo/ct-user
> CT on the web:  http://www.k1ea.com/
>