[na-user] Keyer Question

[Paul Mackanos]

I soldered up the DB-25 on the LPT1 port to support the paddles. This
is the same interface I have been using for years, but finally decided I
needed to put the keyer paddles on it too. Soldered it up according to
the book, and when I plugged it back in, it locked up the keyer sending
alterdate dit & dahs. Checked it out electrically, and it was OK. Anyone
else have this problem, and was the answer to use higher valued
resistors. I used 10K as the manual specified. Thanks in advance
Paul, K2DB

--
Submissions:              na-user@contesting.com
Administrative requests:  na-user-REQUEST@contesting.com
WWW:                      http://www.contesting.com/datom/
Questions:                owner-na-user@contesting.com