[na-user] NA, CVB and FT1000MP

[Full Name]

Hi, all. I am currently looking at firing up the Contest Voice Blaster. Have almost completed
the interface unit and it occurs to me that the DVK socket on the rear of the FT1kMP
could be used. If so, the mike could be plugged into the front panel as normal, with the
interface unit connected to PC and DVK socket only.

Wonder if any one has tried this? I would like to know what CNTL 1 and 2 switch. I assume
Voice in and out would same as the interface board.

Currently I am getting error message : Unable to initialize card and/or driver.  So any advise
on that would be helpful.

Have convinced local club to enter ARRL 10m Contest, using G8D. Mainly beginners, I will
probably do the CW side. (Why do you think I am organising it?)

Regards Chris G3SJJ, (Chairman RSGB HF Contests Committee and adjudicator RSGB IOTA
Contest (currently sorting 1998 IOTA Contest!)


--
Submissions:              na-user@contesting.com
Administrative requests:  na-user-REQUEST@contesting.com
WWW:                      http://www.contesting.com/datom/
Questions:                owner-na-user@contesting.com