[Orion] FW: Orion serial parameters

[Jim McDonald]

1 stop bit worked, which I got from the Programmer's Guide.  NU1U told me to
check CTS, which did the trick.

This information shouldn't be buried in a programmer's guide on another web
site (and the CTS wasn't there); it should be in the manual in a section on
interfacing to logging or control programs.

Thanks, Barry.

Jim N7US

-----Original Message-----
From: Barry N1EU [mailto:n1eu at yahoo.com] 
Sent: Saturday, March 12, 2005 5:17 PM
To: Jim McDonald; Dxbase at mailman.qth.net; orion at contesting.com
Subject: Re: [Orion] FW: Orion serial parameters


Try 2 stop bits.

73,
Barry N1EU

--- Jim McDonald <jim at n7us.net> wrote:
> I can't get DXbase to talk to my new Orion.  I am
> using 57600/8/N/1 but
> nothing.  Have tried a native serial port,
> previously used for my PROII, and
> a Belkin USB/serial converter but no luck.  Any
> suggestions?
> 
> Jim N7US
> 
> 
> 
> 
> _______________________________________________
> Orion mailing list
> Orion at contesting.com 
> http://lists.contesting.com/mailman/listinfo/orion
> 


		
__________________________________ 
Do you Yahoo!? 
Make Yahoo! your home page 
http://www.yahoo.com/r/hs