[Orion] Orion Hardware NB bug from N6BV

[Larry Menzel]

I also was very pleased as I listened around on SS.  Great performance,
again, especially on cw, again, as usual.

I have noticed the same phenomenon but with the DSP noise reduction button.
Sometimes, rarely, I'll notice severe DSP noise reduction on an otherwise
quite situation and realize that even tho it says it's off, it's not.
Usually pushing the button to enable and pushing it again to disable will
cancel the DSP.  Have not had to do any kind of reset to get it back to
normal. 

I have not experience the same thing as BV with the noise blanker, however.

Larry, N0XB
Northfield, MN


Laurence R. Menzel, ChFC, CRC
Regional Marketing Director
Retirement Marketing Specialists
Northfield, MN
 
507 744 4949  voice 
507 744 4950  fax
952 212 2664  mobile


-----Original Message-----
From: orion-bounces at contesting.com [mailto:orion-bounces at contesting.com] On
Behalf Of Bill Tippett
Sent: Monday, November 21, 2005 1:39 PM
To: tentec at contesting.com; orion at contesting.com
Subject: [Orion] Orion Hardware NB bug from N6BV

Just noticed the following in N6BV's Sweepstakes writeup:

"I discovered that the "Hardware NB" (noise blanker) in the Orion doesn't
actually shut off when the front-panel button say "off" -- I discovered this
about 5 hours into the contest when I had to put 18 dB of attenuation in the
front end to prevent terrible buckshot noise. Turning the Hardware NB off
from
the receiver menu cured that problem. Otherwise, the Orion performed
beautifully. It's a keeper."

Not sure which firmware rev Dean was using but I suspect 1.372.

73,  Bill

_______________________________________________
Orion mailing list
Orion at contesting.com
http://lists.contesting.com/mailman/listinfo/orion

-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.1.362 / Virus Database: 267.13.4/176 - Release Date: 11/20/2005