[RFI] Smoke and CO alarms

[MAXXOUT2 at aol.com]

I live in a HUD complex and run an indoor MAG LOOP and at times run a  full 
100 watts.
We have the battery operated First Alert CO-2 detector.
The smoke detector is hard wired but this building has sensors and  detectors 
all over the place.
The apartments are only seperated by sheet rock and the people on  either 
side of me never say anything.
What about a good solid ground and a good choke at the feed point and  not 
the wound up coax type.
Get a big core and put about 10 turns of your coax through  it.
I assume your using good coax.
Beads on the jumoers will take out ground loops.
Bob
AF2Q
 
In a message dated 10/1/2007 8:35:10 PM Eastern Standard Time, n7rt at cox.net  
writes:

I have  the same problem. I could not fix the alarms so I took out the
batteries.  (They even went off with 100 watts).
If there are smoke alarms out there  that don't go off around RF please let
me  know.
N7RT


 



************************************** See what's new at http://www.aol.com