[RTTY] IOGEAR usb to serial cable questions

[Scott Keating]

I'm not using writelog, but I do use a USB/Serial cable (from pccables.com)
with my laptop and a CAT controller for my Yaesu with no troubles at all.

-----Original Message-----
From: rtty-bounces at contesting.com [mailto:rtty-bounces at contesting.com] On
Behalf Of David Ashworth
Sent: Sunday, May 30, 2004 4:42 PM
To: RTTY at contesting.com
Subject: [RTTY] IOGEAR usb to serial cable questions

Greetings fellow RTTY operators.  I have some questions for any of you that
have gotten an  IOGear USB to serial cable to work with a laptop to provide
band/frequency info to Writelog.  I am at a dead end.  Here is my setup:  HP
N3402 laptop with ME and 2000 pro, serial port com1 goes to a rigblaster
interface box to an Icom 706 MkIIG and works fine with the radio.  This is
my portable setup that I have used in several contests,  so far so good.
Now, I am attempting to add the freq/band info to writelog via the usb to
serial cable ,but just can't seem to get this to work.  I have tested this
cable with a tower PC and it will go from USB to serial no problem.  I am
beginning to suspect that it might be something with laptops not putting out
enough to make this work.  I am using this homemade interface between the
706 and the PC:  http://www.qsl.net/g3vgr/civ.html   Thanks so much if
anyone knows the answer.  If nothing else, I have learned a lot about 2000
prof and drivers, etc.  Good luck in the next contest, best regards, Dave,
NC6P.


_______________________________________________
RTTY mailing list
RTTY at contesting.com
http://lists.contesting.com/mailman/listinfo/rtty