[RTTY] what setting to ft100mp user settings for 23hz shift

[Bill Turner]

ORIGINAL MESSAGE:

At 01:50 PM 1/17/2006, FireBrick wrote:


>Using a FT1000MP, MMTTY (which has a 23 hz profile).
>
>What setting should I change to my MP for User Button to do 23HZ.
>I'm connected to the RTTY connector normally doing FSK for rtty.


~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Here are the directions if you are using FSK. For people using AFSK I 
think it is simpler since you should only have to change the MMTTY 
setting and not the transceiver.



For receive: The MMTTY shift selection panel goes up to 23 Hz, but 
you have to scroll. If you don't scroll, it appears that 85 Hz is the 
narrowest. Scroll up and click 23. That sets the receiver.

For transmit: On the Mark V Ft-1000MP, select menu 8-6 in the normal 
way by pressing FAST-ENTER. Above the sub vfo it will say user-set. 
Rotate the sub-vfo knob one step until it says mode. Rotate the main 
vfo knob until it says rtty-l. Go back to the sub vfo and rotate the 
knob till it says rtty-sft. If you've never changed it, the main vfo 
will now say -0.170. Rotate that till it says -.025. (You can not get 
23 Hz since it steps in multiples of 5 Hz, but 2 Hz off doesn't seem 
to matter). Press ENTER to return to normal operation.

At this point you have only set the options, you have not activated 
them. You are still on 170 Hz shift. To activate the options, press 
and hold the PKT button for about one second. You are now on 25 Hz 
shift. To return to normal 170 Hz, press the RTTY button.

Piece of cake when you know how.

Bill, W6WRT