[RTTY] TS-940S

[sjolin]

If your friend has the rig set to FSK, then he has to have an additional 
cable from an AC jack on the back of the rig which supplies the FSK part ( I 
think it's labeled RTTY). If he is using AFSK, then he has to have the rig 
set to SSB.  If he sets the rig to FSK in order to use CW filter without the 
additional cable connection, he wont have any tones.

Not familiar with the Buxcom cable but if there is only connection to 13 pin 
accessory jack, then I don't think FSK will work. Don't know anything about 
the Buxcom in particular. Hope this helps.

If your friend checks his TS-940S manual he will see this connection in the 
setup instructions.

73 de Dave, N0IT

----- Original Message ----- 
From: <w4gkm at juno.com>
To: <rtty at contesting.com>
Sent: Sunday, February 21, 2010 8:00 PM
Subject: [RTTY] TS-940S


>I need some help for a friend who is trying to connect a Kenwood TS-940S 
>via a Buxcom Rascal. Does anyone have any suggestions on this connection. 
>He acquired supposedly the right cable which goes to the 13 pin on the rear 
>of the radio and it will key the radio but no tones.  If anyone has 
>experienced this I would really like to help him out.
>
>
> Nick
> W4GKM
> ____________________________________________________________
> Diet Help
> Cheap Diet Help Tips. Click here.
> http://thirdpartyoffers.juno.com/TGL2131/c?cp=is3HWsjLzBVZYfKYhjUrgQAAJz2m69k4jQbC9g78-uiDh-EbAAYAAAAAAAAAAAAAAAAAAADNAAAAAAAAAAAAAAAAAAAYQAAAAAA=
> _______________________________________________
> RTTY mailing list
> RTTY at contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty