[RTTY] SO2R OT

Don Hill AA5AU aa5au at bellsouth.net
Fri Nov 11 09:37:09 PST 2011


Are you trying to run both radios off the same power supply.  I tried running two radios off a single Icom PS-60 supply and had
strange problems with it.  If not, then sounds like an RFI problem.  Turn the power down and see if the problem still exists.

73, Don AA5AU
http://www.aa5au.com
http://www.rttycontesting.com 

-----Original Message-----
From: rtty-bounces at contesting.com [mailto:rtty-bounces at contesting.com] On Behalf Of Tom Osborne
Sent: Friday, November 11, 2011 10:42 AM
To: RTTY
Subject: [RTTY] SO2R OT

This question is a little off topic, but don't know where else to go.

I'm trying to set up my FT-450AT to use in the WAE.

Whenever I hit the transmit button, the radio shuts off and no RF goes out. 
It's like the voltage is too low.

I put a meter on the power supply and when I key the radio, the voltage stays at 14, but for some reason, the radio won't key up in
RTTY.  I thought maybe the voltage was dropping, but it isn't.  Probably not getting enough current somehow, but I'd think the
voltage would go down if that was happening.

This also happens on my FT-840 adn the TS-450's.  Thanks and 73 and hope to work you in the WAE.
Tom W7WHY



_______________________________________________
RTTY mailing list
RTTY at contesting.com
http://lists.contesting.com/mailman/listinfo/rtty



More information about the RTTY mailing list