[RTTY] FW: RTTY + FT920

Joe Subich, W4TV lists at subich.com
Wed May 9 07:46:56 PDT 2012



> I use a homebrewed FSK keying, so I'm not familiar with the MicroHam
> setup.I don't know if you need to load EXTFSK.DLL or not. I use it
> here because my interface uses a USB to serial converter.
>
> Perhaps Joe/W4TV can assist in getting your MicroHam set up
> properly.

EXTFSK is not necessary with microKEYER, Digikeyer, microKEYER II,
Digikeyer II, micro2R, or MK2R/MK2R+ ... they all provide UART based
interfaces.  USB Interface II and USB Interface III require EXTFSK
as they are not based on a separate microcontroller.

Example configurations for MMTTY with each interface is available
via "Help | Download Documents" in Router or may be viewed/downloaded
on-line at www.microHAM-USA.com/Support.html.

73,

    ... Joe Subich, W4TV
        microHAM America, LLC.
        http://www.microHAM-USA.com
        http://groups.yahoo.com/group/microHAM

        e-mail: support at microHAM.com


On 5/9/2012 10:28 AM, Jim Hargrave wrote:
>
> Rag,
>
> I use a FT-920 on RTTY FSK on a regular basis.
>
> Here is my Radio setup:
>
> Mode DATA-LSB (This defaults to LSB injection)
> AFSK/FSK switch on the rear panel set to FSK.
> Menu U-42 = Hi 2125
> Menu U-43 = 170
> Menu U-44 = Reverse (This depends on the FSK Keying interface)
> FSK keying circuit should be on pin 1 of the Data connector and pin 2 is
> ground.
>
> MMTTY Setup:
> Polarity = Normal
> Setup | TX Tab. Setup the correct FSK com port for your interface
> Setup | MISC tab. Set the TX port to one of the FSK selections.
>
> I use a homebrewed FSK keying, so I'm not familiar with the MicroHam setup.
> I don't know if you need to load EXTFSK.DLL or not. I use it here because my
> interface uses a USB to serial converter.
> Perhaps Joe/W4TV can assist in getting your MicroHam set up properly.
>
> I use MMTTY under Logger32, but the above setting work for the FT-920 and
> MMTTY as a standalone.
>
>      73s de Jim
>         W5IFP
>
>
>    >  -----Original Message-----
>    >  From: rtty-bounces at contesting.com [mailto:rtty-bounces at contesting.com]On
>    >  Behalf Of Stein-Roar Brobakken
>    >  Sent: Wednesday, May 09, 2012 12:53 AM
>    >  To: rtty at contesting.com
>    >  Subject: [RTTY] RTTY + FT920
>    >
>    >
>    >  Hi
>    >
>    >
>    >  Is there anyone out which have used FT-920 with FSK RTTY?
>    >
>    >  I got a FT920 in shack to test for RTTY.
>    >  I have tried to setup mine with a microHAM MKII..switched the
>    >  radio to FSK
>    >  and standard settings..2125 , 170 and also tried with setup in MMTTY..
>    >  But I am not able to copy my sent RTTY at the other end...
>    >  I do see the two spaced tones, but it's not quality RTTY and not able to
>    >  decode it with another transceiver.. and I can either work any QSO :(
>    >
>    >  Any suggestions????
>    >
>    >  73s LA6FJA Rag
>    >
>    >
>    >  _______________________________________________
>    >  RTTY mailing list
>    >  RTTY at contesting.com
>    >  http://lists.contesting.com/mailman/listinfo/rtty
>
> _______________________________________________
> RTTY mailing list
> RTTY at contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>




More information about the RTTY mailing list