[RTTY] FW: RTTY + FT920

Jim Hargrave w5ifp at gvtc.com
Wed May 9 07:28:49 PDT 2012


Rag,

I use a FT-920 on RTTY FSK on a regular basis.

Here is my Radio setup:

Mode DATA-LSB (This defaults to LSB injection)
AFSK/FSK switch on the rear panel set to FSK.
Menu U-42 = Hi 2125
Menu U-43 = 170
Menu U-44 = Reverse (This depends on the FSK Keying interface)
FSK keying circuit should be on pin 1 of the Data connector and pin 2 is
ground.

MMTTY Setup:
Polarity = Normal
Setup | TX Tab. Setup the correct FSK com port for your interface
Setup | MISC tab. Set the TX port to one of the FSK selections.

I use a homebrewed FSK keying, so I'm not familiar with the MicroHam setup.
I don't know if you need to load EXTFSK.DLL or not. I use it here because my
interface uses a USB to serial converter.
Perhaps Joe/W4TV can assist in getting your MicroHam set up properly.

I use MMTTY under Logger32, but the above setting work for the FT-920 and
MMTTY as a standalone.

    73s de Jim
       W5IFP


  > -----Original Message-----
  > From: rtty-bounces at contesting.com [mailto:rtty-bounces at contesting.com]On
  > Behalf Of Stein-Roar Brobakken
  > Sent: Wednesday, May 09, 2012 12:53 AM
  > To: rtty at contesting.com
  > Subject: [RTTY] RTTY + FT920
  >
  >
  > Hi
  >
  >
  > Is there anyone out which have used FT-920 with FSK RTTY?
  >
  > I got a FT920 in shack to test for RTTY.
  > I have tried to setup mine with a microHAM MKII..switched the
  > radio to FSK
  > and standard settings..2125 , 170 and also tried with setup in MMTTY..
  > But I am not able to copy my sent RTTY at the other end...
  > I do see the two spaced tones, but it's not quality RTTY and not able to
  > decode it with another transceiver.. and I can either work any QSO :(
  >
  > Any suggestions????
  >
  > 73s LA6FJA Rag
  >
  >
  > _______________________________________________
  > RTTY mailing list
  > RTTY at contesting.com
  > http://lists.contesting.com/mailman/listinfo/rtty



More information about the RTTY mailing list