[RTTY] 75 baud question

[David VE3VID]

Thanks AlThat sounds easy enough,  just didn't want to miss a step.cheersDavid


http://www.ve3vid.webs.com/


> From: akozak at hourglass.com
> To: ve3vid at hotmail.com; n1mmlogger-digital at yahoogroups.com; rtty at contesting.com
> Date: Wed, 24 Apr 2013 14:17:36 -0400
> Subject: Re: [RTTY] 75 baud question
> 
> The MMTTY engine takes care of everything.  75 baud RTTY is still 170Hz shift between mark and space.  The only difference is the baud rate set for the UART.
> 
> Al
> AB2ZY
> 
> ________________________________________
> From: RTTY [rtty-bounces at contesting.com] On Behalf Of David VE3VID [ve3vid at hotmail.com]
> Sent: Wednesday, April 24, 2013 2:14 PM
> To: N1MM Digital; RTTY contest group
> Subject: [RTTY] 75 baud question
> 
> I would like to try 75 baud in the BARTG event but am unsure on how to set this up.   Currently using MMTTY with N1MM, set up for FSK done by a Kenwood TS-450.
> What settings need to be able to do 75 baud?
> The TS450 has FSK shift settings of 200 450 and 850hz.  Do I set one of these for 75 baud?
> On MMTTY setup under Decode tab, BaudRate setting - Is this the only adjustment for MMTTY?
> 73David
> 
> 
>     VE3VID
> Located in rural Canada
> Solar power.  Wood heat.
> Mosley tribander @ 10m
> Lots of space for dipoles,
> bears and wolves......73
> 
> http://www.ve3vid.webs.com/
> 
> _______________________________________________
> RTTY mailing list
> RTTY at contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
> _______________________________________________
> RTTY mailing list
> RTTY at contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty