[RTTY] 75 baud question

[Joe Subich, W4TV]

How are you generating FSK (what interface)?

In all cases you will need a *real* serial port capable of operating
at 75 baud, an interface like microHAM Digikeyer, Digikeyer II,
microKEYER or microKEYER II capable of operating at 75 baud or you
will need to use AFSK.

Only the Edgeport line of USB to serial adapters are currently
capable of operating at 45.45 and 75 baud without EXTFSK in MMTTY.
EXTFSK is limited to 45.45 baud.

73,

    ... Joe, W4TV


On 4/24/2013 2:14 PM, David VE3VID wrote:
> I would like to try 75 baud in the BARTG event but am unsure on how to set this up.   Currently using MMTTY with N1MM, set up for FSK done by a Kenwood TS-450.
> What settings need to be able to do 75 baud?
> The TS450 has FSK shift settings of 200 450 and 850hz.  Do I set one of these for 75 baud?
> On MMTTY setup under Decode tab, BaudRate setting - Is this the only adjustment for MMTTY?
> 73David
>
>
>      VE3VID
> Located in rural Canada
> Solar power.  Wood heat.
> Mosley tribander @ 10m
> Lots of space for dipoles,
> bears and wolves......73
>
> http://www.ve3vid.webs.com/
>   		 	   		
> _______________________________________________
> RTTY mailing list
> RTTY at contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>