[RTTY] BARTG 75 Sprint calls

[Gary AL9A]

For some reason in this one I noticed a significant increase in the number 
of stations that called and tried to work me at 45 baud instead of 75.  I 
got so tired of manually typing "SEND 75 BAUD NOT 45" or something close to 
that I wished I had made a macro someplace to save my finger tips.  I 
couldn't figure out how someone who was setup for 45 baud could call me at 
that speed when all they could receive was gibberish.  Now I suspect two 
possible scenarios could factor into this, but I'm not sure of #1.

1. Someone has setup MMTTY on the Decode tab to receive 75 baud, but missed 
clearing the little check box on the Demodulator tab that "Fixes 45.45 
baud".  So my question is if someone did this would he be able to decode my 
transmissions at 75 baud, but then when he sent his macros they came out at 
45 baud?

2. A much more likely scenario is that a few saw my call spotted on the DX 
cluster and ran there to pick up a AK RTTY contact despite the fact that 
they couldn't decode what I was sending!

Do either of these assumptions seem likely?  Not sure what to do about it in 
the future.  One thing I will not do is shift my speed back down to 45 to 
tell the uninformed at the other end to increase his speed to 75.  That is 
sure to result in my pile up disappearing when the other guy needs 
instructions on how to change his baud rate!

73,
Gary AL9A