[RTTY] [GRITTY.INI and tone figures

[Alex, VE3NEA]

Hi Phil,

Stop Gritty before editing the ini file, then save your changes and run the program again.

73 Alex VE3NEA



On 2016-03-18 14:54, Phil Cooper wrote:
> Hi Alex and the group,
>
> I just downloaded v1.3 (I was using 1.2) and used the drop down to select
> Data Files and then I opened GRITTY.INI from there.
> The high tone was set to 2295, so I changed that to 1445, saved it and
> closed the file.
> When I opened GRITTY afterwards, the tones still showed as being at 2295. I
> tried this several times, but each time I closed GRITTY, the ini file
> reverted back to 2295.
>
> However, when I navigated to C:\Users\MyName\...... etc, to where GRITTY.INI
> resides, and then changed it to 1445, that saved it, and now when I open
> GRITTY, it is set at the right tone pair for me.
>
> I'm not sure why this should be, but it's all sorted now.
>
> For some reason, I just can't hack the high tones. I have tried several
> times over the years, as it would be useful as my radio offers advantages by
> using them, but I just can't tune them in easily. On the other band, I can
> get to within 2 or 3Hz of a signal using the low tone pair simply be ear
> alone.
> Must be an age thing!
>
> 73 de Phil GU0SUP
>
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
>
> _______________________________________________
> RTTY mailing list
> RTTY at contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
>