[SCCC] [TowerTalk] Ham IV

[Ray Benny]

Dennis,

Idiom Press has a multi LED replacement for the 24 volt, 1819. You have to
assemble and make about 10 solder connections onto a small circuit board.
The board then attaches to the top of the meter.

http://www.idiompress.com/illuminator.html

I just purchased two of them, they work fine.

Ray,
N6VR 

-----Original Message-----
From: towertalk-bounces at contesting.com
[mailto:towertalk-bounces at contesting.com] On Behalf Of Dennis Vernacchia
Sent: Friday, June 12, 2009 11:58 PM
To: Darl Deeds
Cc: towertalk
Subject: Re: [TowerTalk] Ham IV

Darl,

Easy to replace - just remove top cover

It uses a type 1819 and if U neber want to have to replace the bulbs again
this advice from K6EL in a previous post

He wrote:

You may want to replace it with a direct replacement LED.
I just was alerted to this web page and it is awesome! I ordered a
couple for the box to check them out and they are very high quality. No
minimum order and very quick service.
https://www.superbrightleds.com/led_prods.htm

73, Dennis N6KI


On Fri, Jun 12, 2009 at 6:42 AM, Darl Deeds <ddeeds at thewavz.com> wrote:

> Hi all. I have a Ham IV rotor from Hygain. I have the version that has two
> bulbs in the control box. Both bulbs have blown. I see nothing in the
manual
> about changing them and in looking at them it looks like a total pain to
> change them. Are there any suggestions for an alternative or a good way to
> change them.  Thanks in advance.
>
> Darl   NA8W
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk