[SCCC] N1MM with Icom 7600 interface

[J. Richard Low]

The universal serial bus cable carries rig control (CAT) via a
USB-TO-SERIAL converter in the 7600, as well as the USB sound card/codec in
the 7600 for the digital sound card modes like PSK31 and AFSK RTTY.

To do CW I use a Winkeyer on a separate USB/comport on the computer and
tell N1MM the proper port for the Winkeyer. The Winkeyer then feeds the CW
keying signal to  the 7600's key input on the rear panel. N1MM tells the
Winkeyer what to send. This can be one of the N1MM CW memories or manual CW
from the computer's keyboard (CTRL+K?).

There are probably other external keyers out there but I've found the
Winkeyer to be the easiest to use.

73 Rick N6CY
On Oct 11, 2015 3:55 PM, "Ray Biederman via SCCC" <sccc at contesting.com>
wrote:

> I am trying to get the N1MM program to work with my Icom 7600.  Program is
> working but need some type of interface to go between the computer and
> radio (IC 7600) to send CW from the keyboard.  I have the USB cable in
> place (1st cable) but apparently need a 2nd cable and interface for CW
> operation from the keyboard.  Has anyone run into this problem and solved
> it?  Ray  WB6L  wb6l at aol.com
> _______________________________________________
> SCCC mailing list
> SCCC at contesting.com
> http://lists.contesting.com/mailman/listinfo/sccc
>