[SEDXC] BOLTS

[David Johnson]

Hey Mike,

You want me to bring these to the hamfest?

Dave - K4SSU


----- Original Message ----- 
From: "k4pi" <k4pi at bellsouth.net>
To: "SEDXC" <sedxc at contesting.com>
Sent: Thursday, October 23, 2008 12:59 PM
Subject: [SEDXC] BOLTS


> This is for you guys with a lot of Rohn 25 hardware laying around.  I am
> looking for some Grade # 5, galvanized, 3/8 X 2 1/2.  These bolts were 
> used
> in the old style torque arm assembly that Rohn sold.  They now have a new
> type assembly that uses larger bolts.  To save some of you emails here is
> where I have checked..
> McMaster, Grainger, Fastenal, MSC, Tractor Supply, Lowes, Home Depot, 
> K4XS,
> numerous hardware stores.. etc.  The nut and bolt companies normally want 
> to
> sell by the 100.  I only need about 4.  Would take a few more if avalible.
> I can find plenty of Grade # 5 non galvanized and may have to go with 
> those
> but would prefer the Rohn ones..  They also used a nut that had a much
> larger outside diameter than standard nuts if I could find those also. 
> Just
> trying to go back with the same Rohn material.  73 Mike K4PI
>
> _______________________________________________
> SEDXC mailing list
> SEDXC at contesting.com
> http://lists.contesting.com/mailman/listinfo/sedxc