[SEDXC] Steppir SDA 100 controller.

[Mack McCormick]

Phillip,

The best place, in my opinion, to get help with SteppIR issues is over on
the groups.io group.

That said, over there is a list of troubleshooting steps which include
checking SteppIR motor resistances and voltages. Finally you’ll need to
replace the driver chip. I’ve had to replace driver chips several times and
the newer controllers use sockets for these chips. Chips are available for
sale at Mouser and perhaps other sources.

Good luck.

Mack
W4AX

On Fri, Nov 26, 2021 at 10:06 Phillip <kf4uyk at bellsouth.net> wrote:

> I purchased a new controller from steppir for my 14 year old three element
> steppir. As soon as I connected it I received a chip error message. Has
> anyone in the club had the same experience? Any suggestions
> Thanks
> Phillip Kf4uyk
>
> Sent from my iPhone
> Phillip T Williams
>
>
> _______________________________________________
> SEDXC mailing list
> SEDXC at contesting.com
> http://lists.contesting.com/mailman/listinfo/sedxc
>
-- 

73,

Mack
W4AX
https://www.qrz.com/db/W4AX