[Skimmertalk] QS1R current consumtion

[Igor Sokolov]

Thanks David,
Running skimmer server, 6 bands at 96 KHz. The same setup had been run 
before but power consumption was less (under 1 Amp)

73, Igor UA9CDC
----- Original Message ----- 
From: "David Robbins" <k1ttt at arrl.net>
To: <skimmertalk at contesting.com>
Sent: Saturday, November 01, 2014 4:53 PM
Subject: Re: [Skimmertalk] QS1R current consumtion


> What were you running before??   the 1.6a sounds about right for the QS1R 
> if
> you are running SkimmerServer software, it uses much more of the 
> processing
> power of the QS1R than other software.  If you change the number of bands 
> or
> the bandwidth the power consumption changes.
>
> David Robbins K1TTT
> e-mail: mailto:k1ttt at arrl.net
> web: http://wiki.k1ttt.net
> AR-Cluster node: 145.69MHz or telnet://k1ttt.net
>
>
> -----Original Message-----
> From: Skimmertalk [mailto:skimmertalk-bounces at contesting.com] On Behalf Of
> Igor Sokolov
> Sent: Saturday, November 01, 2014 06:10
> To: skimmertalk at contesting.com
> Subject: [Skimmertalk] QS1R current consumtion
>
> Hi all,
> After updating RU9CZD skimmer  (QS1R based) to the newest skimmer software
> our QS1R current consumption increased to 1.6 Amp. Is it normal or should 
> we
> suspect problem in QS1R?
>
> 73, Igor UA9CDC
>
> _______________________________________________
> Skimmertalk mailing list
> Skimmertalk at contesting.com
> http://dayton.contesting.com/mailman/listinfo/skimmertalk
>
> _______________________________________________
> Skimmertalk mailing list
> Skimmertalk at contesting.com
> http://dayton.contesting.com/mailman/listinfo/skimmertalk