[Skimmertalk] Communication CW Skimmer <=> FT2000 - help needed

[Pete Smith N4ZR]

Hello, Thomas.  I don't know the FT-2000.  I have a K-3 with the 
separate sub-receiver, which enables me to reverse the roles of the two 
VFOs so that I can receive on VFO B and transmit on VFO A.  This works 
well in the K1N pileups.

To the best of my knowledge, Omnirig only monitors VFO A, but you may 
want to ask VE3NEA directly.

73, Pete N4ZR
Check out the Reverse Beacon Network at
http://reversebeacon.net,
blog at reversebeacon.blogspot.com.
For spots, please go to your favorite
ARC V6 or VE7CC DX cluster node.

On 2/5/2015 4:02 PM, Gabriele Herrmann wrote:
> I enjoy CW Skimmer soft for years now. CW Skimmer is connected with FT2000 via microHAM urouter and CAT controles FT2000 by Omnirig and FT2000.ini comand set. All together works flawless.
>
> During last few days, while hunting K1N, split range more often was much larger than shown frequency range by CW Skimmer (about 10kHz). Because each frequency set in CW Skimmer changes frequency of main RX VFO-A, I have to switch between main RX VFO-A and sub RX VFO-B, to monitore split range above 10 kHz.
>
> My question is:
> how to modify communication between CW Skimmer and FT2000 for changing sub VFO-B by CW Skimmer instead of changing main VFO-A ?
>
> My goal: keep main VFO-A fix for RXing (the DX) and change sub VFO-B for TXing in split range, supported by CW Skimmer.
>
> Any hints ?
> Thank You in advance.
> Thomas, DL1AMQ
>
>    
> _______________________________________________
> Skimmertalk mailing list
> Skimmertalk at contesting.com
> http://dayton.contesting.com/mailman/listinfo/skimmertalk
>