[Skimmertalk] RTTY Skimmer 1.3 SDRPlay Windows 10

[Bob Wilson, N6TV]

Try copying the Qs1rIntf.dll back into the RTTYSkimServ directory, even
though you're not connecting it.  I had trouble getting my Red Pitaya to
work with CWSL_Tee.dll and RttySkimServ when that QS1R file was missing; I
think the Skimmer software loads it then ignores it, but that doesn't work
if it's not there, but that's just a guess.

Did you update RttySkimServ.ini to select the correct SDR?

73,
Bob, N6TV

On Wed, Jul 25, 2018 at 5:47 AM, Arthur Bard via Skimmertalk <
skimmertalk at contesting.com> wrote:

> Note. I previously had this setup working on a Windows 7 PC.
> Set up a new PC (well really a new HDD in the existing PC after removing
> the old HDD) installed RTTY Skimmer Server 1.3 on a Windows 10 64bit PC
> into a writable folder called Radio off of the C:\ root, fired it up and as
> expected it complained that it could not see my SDRPlay RSP 2, fine all
> looking good so far.
> So powered it down, deleted the installed Qs1rIntf.dll file and installed
> the SDRPlayIntf.dll file from Steve N2IC.  Started RTTY Skimmer Server 1.3
> again and it complained that it cannot load the interface DLL i.e.
> Steve's SDRPlayIntf.dll.
> Has anyone got this working on a Windows 10 64bit PC if so any pointers to
> what my problem is.
> Regards Arthur G1XKZ
> _______________________________________________
> Skimmertalk mailing list
> Skimmertalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/skimmertalk
>