OMNI VI R.I.T. MOD

[James C. Owen, III]

In message 06 Nov 96 16:09:35 EST,
  "Ten-Tec, Inc." <74130.212@CompuServe.COM>  writes:

> The C1-C4 display board to ground was our fix for this problem.  You
> may want to call our service dept and pick their collective brains
> a little and see if they have any other suggestions.
>

 It was fine before the logic upgrade to give a choice of tuning
> speeds. At least I can set the main tuning slow enough to not need the
> RIT if I use split, but that ignores the problem instead of fixing it.
> Hey Ten-Tec! Have you found a solution yet?
> Jim
>
Pardon me if I'm missing something here Jim BUT the rig worked fine before
the software upgrade and now doesn't. I don't think that you have a hardware
problem. I would suspect bad software or if it is on a plug-in PROM a bent
pin or poor connection. I don't see how you get a sudden hardware problem
with a change in software. 73 Jim K4CGY

--
FAQ on WWW:               http://www.contesting.com/tentecfaq.html
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 w9tw@contesting.com
Sponsored by:             Akorn Access, Inc & KM9P