[TenTec] Omni VI owners

James C. Owen, III owen@piper.eeel.nist.gov
Wed, 26 Feb 1997 11:24:27 -0500 (EST)


In message Wed, 26 Feb 1997 05:39:43 -0800,
  Steve Milewski <milewski@OREGON.UOREGON.EDU>  writes:


>
> The only area where I've noticed the Omni seems to fall short is on 40
> meters. 40 seems to have a number of stations that have extremely bad key
> clicks. My Omni has been very susceptible to some of these stations and
> there have been instances where I will hear stations as far away as 20 -
> 25 khz up/down the band (not a mistake-that's khz not hz).
>
> These are not local stations either. My QTH is Marcola, OR (in the rural
> area outside Eugene) and the QTHs of the stations I'm talking about have
> been in California, Montana and a few other Western States.
>
Steve,
   This is not a fault of the Omni VI. These are actual signals radiated by
the stations with the key clicks and they fall on the frequency to which you
are listening. There is no way for you to clean them up. I have the same
problem with a station on 14.448 Mhz that wipes out the upper end of 20
meters. I hear it on the Corsair II, the TS-130 and the Drake C line--not a
problem with the rig. 73 Jim K4CGY

--
FAQ on WWW:               http://www.contesting.com/TenTecFAQ.html
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Sponsored by:             Akorn Access, Inc. & N4VJ / K4AAA