[TenTec] Scout 555 RFI modification.

[Allan K Chapman]

Design oversight resulted in various problems in some Scouts, due to 
stray RF feeding back  into the transceiver on the  (UNFILTERED!)  power
lead.  

Correction simply requires installation of  two basic parts on the DC
supply line just INSIDE the case: A 100 pF ceramic disc, and one Amidon
type 77 ferromagnetic bead.  Connect the cap across the +/-  leads; place
the bead (with two turns) on the positive wire.  Both need to be as close
as possible to the power connector.  You will need to extend the red +
lead a few inches to give you enough wire for the two turns you will make
through the bead.  Total cost less than a buck and  about an hour.


73 de Allan  W6MEO@KJ6FY.#NCA.CA.USA.NOAM
                     a.k.chapman@ieee.org

_____________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com
Or call Juno at (800) 654-JUNO [654-5866]

--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm