[TenTec] Omni vi+ optical encoder

[Ariel Elam]

Hi to All--I have had to replace the tuning encoder on my VI+. Cost
$43.98 shipped from TT. Check the rit encoderfor drag. I believe they
are the same devices, as TT adaised me to interchange their cables(55 &
56 as i remember) to make the rit control do main tuning. perhaps your
rit control has little drag and main tuning drag would be acceptableon
rit. If so, you could then interchange the controls. But then, how long
would the draging control last?

Ten-Tec forever!
73, Ariel,k4aal

John Dvoracek wrote:
> 
> How tight is the tuning encoder on an omni vi+?  I have no tension on my
> tuning knob; in fact I have moved the knob out slightly on the encoder shaft
> so there is complete clearance between the front panel and the friction
> pads.  The resistance to turning the tuning knob is still more than I would
> like.  I have used only one other vi+, and ac5aa's knob was easier to turn.
> Has anyone replaced the encoder, or does anyone know how much TT charges for
> a new encoder, or are there other sources for the encoder?  I am thinking of
> trying that just to know for sure - I have done some prior front panel work,
> and I know that requires caution and patience.  THANKS!
> 73, de ke5c, op John
> 
> --
> FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
> Submissions:              tentec@contesting.com
> Administrative requests:  tentec-REQUEST@contesting.com
> Problems:                 owner-tentec@contesting.com
> Search:                   http://www.contesting.com/km9p/search.htm

--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm