[TenTec] Pegasus beta software

[Steve Ellington N4LQ]

I can't see the Pegasus controlling the Hercules unless an interface
is installed. The Herc requires a gounded lead to activate each band
relay. It was easy rigging it up with the old Omni C but the Pegasus
has no external connector. After looking over the schematic of the
Pegasus, it wouldn't be difficult at all to tap into the coil of each
band relay and use those voltages to activate small relays external to
the rig and key the Herc. All it would take is some multiconductor
wire and no software changes are needed.
Steve N4LQ
----- Original Message -----
From: "Greg Hodsdon" <k7kj@teleport.com>
To: "tentec" <tentec@contesting.com>
Sent: Sunday, December 19, 1999 1:55 PM
Subject: [TenTec] Pegasus beta software


>
> TenTec has beta version 1.63x4 posted on it's website. Among the
added
> features is the ability to exchange frequency and mode information
with
> other programs. This opens the door to much greater flexibility with
the
> Pegasus control program such as band data on the computer port.
Perhaps
> auto bandswitching of the Hercules II amp is not too far away.
> Greg, K7KJ
> Portland, OR
>
>
> --
> FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
> Submissions:              tentec@contesting.com
> Administrative requests:  tentec-REQUEST@contesting.com
> Problems:                 owner-tentec@contesting.com
> Search:                   http://www.contesting.com/km9p/search.htm
>
>


--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm