[TenTec] Jupiter line command

[Mark Erbaugh]

On the Jupiter and Pegasus the line in and mic in can only be selected one
at a time. It would be nice if the software were written to automatically
switch to line in for voice keyer and back to mic.  Alternatively, the line
in and mic in have the same circuitry so maybe you could build a little
outboard mixer that would feed both mic and computer to the same input on
the Jupiter.

73,
Mark

----- Original Message -----
From: "Chris Robson" <crobson@robsonco.com>
To: <tentec@contesting.com>
Sent: Monday, June 10, 2002 17:53 PM
Subject: [TenTec] Jupiter line command


> Hi All,
>
> After getting an opportunity to simulate the contesting mode using the
> Jupiter, what I found is I can have to either set the mic on or line on,
> not both on, to use the audio in and audio out. Unlike my Omni 6, which
has
> the ability to use the audio in/out while using the microphone, the
Jupiter
> can not have the audio in/out active when using the mic jack. This was
> discovered when I tried to use the audio in/out jacks on the Jupiter to
> send voice exchanges with the voice keyer capability of the contest
> software. It worked great when I set the line ON command, but then I had
no
> mic capability. Is there a way to have both on? Is this a software
> change?  Any answers?
> 73, Chris KB3A
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>