[TenTec] SB-610 Interface]

[Bill Marvin KB9IV]

Mark, the 610's IF frequency is wired for 455 Khz or 3395(Heathkit). The Corsair is at
either 6 or 9 Mhz IF's........it isn't possible without massive redesign on either
device.

Best 73,

Bill KB9IV




-------- Original Message --------
Subject: [TenTec] SB-610 Interface
Date: Mon, 21 Oct 2002 15:25:03 -0600
From: Mark Hoffman <markah@bigplanet.com>
To: tentec@contesting.com

I have a Heath SB-610 Station Monitor that I would like to interface to
my Corsair I for receive signals.  I already successfully use it for
transmit signal monitoring.  Before I start digging into the Corsair
electronics, has anyone done this or has any suggestions?

Mark
W7GCY



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec