[TenTec] Omni-V Question

[Robert & Linda McGraw K4TAX]

Sounds like dirty connectors between power supply and transceiver.  Also,
make sure fuse is clean and fuse holder is not cracked.  Mine was and thus
had to be replaced.

73
Bob, K4TAX

----- Original Message ----- 
From: "Cornell" <cornell at redshift.com>
To: <tentec at contesting.com>
Sent: Thursday, June 19, 2003 11:59 PM
Subject: [TenTec] Omni-V Question


>
> Omni-V model 562 ...
>
> When placed in tune, shuts down at about 75-80 watts. Lamps remain on,
power
> out goes to zero, and display blanks. There is no noise when this occurs.
> Input is 12.6 volts. Recycle of power switch restores normal operation.
> Happens on all bands. Also happens on SSB if power level is set too high
and
> mic gain is increased.
>
> Any assist would be welcome. Please reply to below e-mail. Thanks.
>
> Max K0MC
> Marina, Ca
> cornell at redshift.com
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>