[TenTec] audio

George, W5YR w5yr at att.net
Fri Nov 7 09:07:26 EST 2003


One would expect that, as a software-defined radio, the functions of the
ORION ACCY pins would be determined by the control program. In that way,
given the proper menu provisions, the operator could define the pin
functions as needed for a specific application.

73/72, George
Amateur Radio W5YR -  the Yellow Rose of Texas
Fairview, TX 30 mi NE of Dallas in Collin county EM13QE
"Starting the 58th year and it just keeps getting better!"
w5yr at att.net





----- Original Message ----- 
From: "Mark Erbaugh" <mark at microenh.com>
To: <tentec at contesting.com>
Sent: Friday, November 07, 2003 8:13 AM
Subject: Re: [TenTec] audio


> Jack,
>
> When I had an Orion back in August, I noticed that the audio setup to the
> back ACCY jack was inconsistent.  While you can control which audio goes
to
> the speaker and to the right and/or left headphone, you have no control
over
> what audio goes to the ACCY jack. I mentioned this to TT and they replied
> that there is no hardware provision for routing the ACCY jack audio. The
> manual that came with my Orion (the original manual - I think there's been
> an update released) said that the ACCY jack was a 5 pin DIN and that the
> pinout was similar to that on the Pegasas / Jupiter. However, the actual
> jack is an 8 pin DIN and one of the extra pins has audio out as well. From
> what I understand, each of these pins is connected to a different DSP
> processor. If that processor is used for audio going to one of the other
> destinations (headphone / speaker) that audio will be present on the ACCY
> jack. If it is not being used, there will be no audio.
>
> It really seems a shame that on such a high end, where folks will be
wanting
> to use it with a soundcard that TT didn't provide audio routing for the
ACCY
> output.
>
> 73,
> Mark
>
> ----- Original Message ----- 
> From: "jack" <jfriend31 at comcast.net>
> To: <tentec at contesting.com>
> Sent: Wednesday, November 05, 2003 8:48 PM
> Subject: [TenTec] audio
>
>
> > under AUDIO i set the SPKR to MAIN only and eliminated SUB RX audio in
the
> > Orion's speaker but it still comes thru the audio card in my computer
> >
> > jack
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec at contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec



More information about the TenTec mailing list