[TenTec] DXBase Setup

RM royalct at inr.net
Wed Aug 4 20:34:14 EDT 2004


In Dxbase 2005 set the following parameters;

Baud Rate -> 57000
Word Length -> 8 bits
Parity -> None
Stop Bits -> 1 
CTS checked high (DTR High and RTS High are not checked with the computer's
serial card set to the following:

Serial port to 57000, 8 bits, no Parity, 1 stop bit, Flow control set to
hardware --- Before the rest of you flame me and telling me that the
computer detects and sets up its serial port, remember that not all computer
serial ports are created equal.


-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of Sherman Banks
Sent: Tuesday, August 03, 2004 21:51
To: Ten Tec
Subject: [TenTec] DXBase Setup

Can someone email me the settings for the serial port setup in DXBase for
the Orion?

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




More information about the TenTec mailing list