[TenTec] Firmware upgrade and Keyer timing

[Gary Tuck]

Is anyone else been having problems with keyer timing after the 
upgrade?  I see the new choice in the CW menu and have chosen Mode B 
which is what I think I learned with my old Heath keyer, and I assume 
what was built into the 1.371 and before.  But now, my "K" becomes an 
"M" half the time and my "R" becomes an "A".   I trudge along at about 
22 wpm, but had no problems of this nature sending prior to 1.372.   If 
I choose Mode A, I have the same problem so wondering if it's stuck in 
Mode A??

After install, I did a Ram-clear and answered all questions Yes and 
also a master reset. All other functions seem to be working OK.   I had 
read somewhere on the List that one should uncheck the box about 
"stopping on error" which I did----so the program could not verify the 
installation.  Is it possible that this could be the source of the 
problem?

tnx, Gary