[TenTec] Firmware upgrade and Keyer timing

[A. Sewell]

Gary,

I use only Mode B and can't tell any difference between 1.371 & 1.372.  
I think 1.371 and before was only Mode B.  In fact, I can't tell any 
difference between Mode A & Mode B in 1.372.  I usually have a problem 
when trying to use keyers that are set to Mode A.  I think Mode A in 
1.372 is not really Mode A.

I also did a ram clear.  My keyer didn't work after the ram clear so I 
did a master reset.  Everything OK after the master reset.

73,

Alan  N5NA


Gary Tuck wrote:

> Is anyone else been having problems with keyer timing after the 
> upgrade?  I see the new choice in the CW menu and have chosen Mode B 
> which is what I think I learned with my old Heath keyer, and I assume 
> what was built into the 1.371 and before.  But now, my "K" becomes an 
> "M" half the time and my "R" becomes an "A".   I trudge along at about 
> 22 wpm, but had no problems of this nature sending prior to 1.372.   
> If I choose Mode A, I have the same problem so wondering if it's stuck 
> in Mode A??
>