[TenTec] N4PY Software Version 2.19 Released

[Carl Moreschi]

I have sent out version 2.19 of my Pegasus/Jupiter/Argonaut
V/Rx320/Rx340/Rx350 control program.  All registered users should now have
it.  See my webpage at www.n4py.com.

Highlites of Version 2.19:

Version 2.19

  1)
  Added a keyer speed query command to the startup sequence for the K2.

  2)
  Added support for the K1EL WinKey keyer.

  3)
  Swapped the order for the hang and delay slider for programmable AGC
  for the rx340.  Also changed the lower limit for hang to 0.0.

  4)
  Added an "ssbrtty.dat" file to control the RTTY and SSB frequencies
  for automode selection during direct frequency entry.

  5)
  Added new pod button to stop and start the frequency scan.

  6)
  Added a separate VFO B step size.  This step size is setable
  through "A/B", "A=B", a VFO B mode change, or right clicking a
  step button. The VFO B step size is shown just below the VFO B
  filter width.





Carl Moreschi N4PY
Franklinton, NC