[TenTec] Re: TX Audio Rolloff [Was: Question regarding Omni VI+ on SSB]

[doc]

Jim Brown wrote:
> I've never owned a Jupiter, so this is an educated guess. I suspect it is a 
> low-cut for the transmit audio. I would set it by ear listening to your 
> transmit audio and by getting signal reports from smart guys on the 
> other end, but somewhere in the 400 Hz range is probably a good 
> starting point.  
> 
> Think of it this way -- anything below 400 Hz is useless for 
> communications.  Telephones, for example, transmit nothing below 
> about 400 Hz.   But your mic will produce a lot of audio below 400 Hz, 
> and that will use up transmitter power. so filtering it out is a good thing. 


I have not had the time to explore my Jupiter settings --
are you saying that the settings allow the user to select
both upper and lower level rolloff?

So you'd recommend rolloff below 400 and above 2,000?

-- 
Thanks! & 73, doc kd4e
West Central Florida  100% Linux.  Suse 9.2
Drake, Icom, Hallicrafters, Heathkit, TenTec, Yaesu
Radio Life: http://www.gospelcom.net/twr/
Linux-Incompatible hardware is defective!
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~