[TenTec] HInts for troubleshooting an OMNI D

[Steve Baron - KB3MM]

bsd crystal?  All other bands ok/
----- Original Message ----- 
From: "Patti" <pthielking at earthlink.net>
To: <tentec at contesting.com>
Sent: Saturday, December 24, 2005 14:23
Subject: [TenTec] HInts for troubleshooting an OMNI D


> Intermittantly, while operating on 80m (sending or just receiving)  my
OMNI D will fade out, with
> the display simply reading 1.000.  Once this occurs, you can no longer
send and receive.
>
> Turning the power off momentarily, or changing bands seems to help, for a
short duration.
> This behaviour only occurs on 80.
>
>
> Any ideas on where to start looking?  From reading the manual, I
considered the VFO AMP board, although this is not band dependant.
>
> Any ideas would be appreciated.  I can be contacted off list as well.
>
> Thanks
> Eric Thielking
> NC2W
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>