[TenTec] OUT OF HAM BAND MODIFICATION

[joel hallas]

Folks,

Sorry to say the chart formatting was lost in transition. Here it is, 
hopefully readable.

> BTW, I put the appropriate offset channels in memory to make sure I 
> end up in the right place, per the ARRL Web page:
>
> This chart from the NTIA suggests appropriate tuning frequencies for 
> each center-channel frequency:
>
> Channel Center                               Amateur Tuning Frequency 
> (USB only)
>
> 5332 kHz                                       5330.5 kHz
>
> 5348 kHz                                       5346.5 kHz
>
> 5368 kHz                                       5366.5 kHz
>
> 5373 kHz                                       5371.5 kHz
>
> 5405 kHz (common US/UK)         5403.5 kHz
>
> In case anyone hasn't seen the chart.
>
> 73, Joel, W1ZR
>
>
> Jim Bull wrote:
>
>> Bob,
>> On my two Paragon's, the MARS/CAP/60M mod is accomplished by 
>> cutting/unsoldering the jumper wire on the logic board (Labeled "HAM")
>> and resetting the processor.  The jumper is located directly below the
>> 9 volt memory battery.
>>
>> NOW, if someone can tell me what/where the mod is on the Paragon II,
>> I would appreciate it VERY much.
>>
>> Jim/Ke3nK
>> ,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
>>
>> Robert Lutz wrote:
>>
>>> Does anyone have the modification to make the Paragon transmit out of
>>> band
>>>
>>> tnx  73   Bob
>>>
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>