[TenTec] mod 961 PS repair

[Jerry Volpe]

A technique often used is to cut the blown track away just at the points 
where it is still valid. Remove any resist from the last 1/4 inch or so 
of remaining trace. Drill wire guage holes at the end of each 
disconnected trace and then solder an appropriate length of solid core 
insulated wire between them and then epoxy tack the wire to the board in 
the same path as the original trace.

73,
Jerry, KG6TT

Vicenç wrote:

>I am looking for conductive tape to repair a blown track of the
>rectifier board of my 961 PS. I have been trying to find it in EA with
>no results and I was wondering if someone on the list would be so kind
>of providing some clues to find it. In any case one or two feet of tape
>(about ¼” width) would be more than enough to repair the track.
>Unfortunately I was unable to get a spare PC board from Ten Tec. Any
>comments or suggestions would be welcome.
>Thanks in advance and 72 de Vicenç, EA3ADV 
> 
>_______________________________________________
>TenTec mailing list
>TenTec at contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>  
>