[TenTec] Ten Tec and Butternut HF6V Problem And Question

EA5YN Vicente Pastor ea5yn at telefonica.net
Tue Jun 28 16:53:56 EDT 2005


Hello, I do not have problem with my Orion and Butternut Hf6V. Full output .
73 and Dx
Vicente EA5YN

----- Original Message ----- 
From: "Dennis McAlpine" <dennis.mcalpine at verizon.net>
To: "'Steve Baron - KB3MM'" <SteveBaron at StarLinX.com>; "'Discussion of
Ten-Tec Equipment'" <tentec at contesting.com>
Sent: Tuesday, June 28, 2005 4:39 PM
Subject: Re: [TenTec] Ten Tec and Butternut HF6V Problem And Question


> I have had a similar problem with my Orion and an old HF6-V with power out
> of about 70 watts according to an external Daiwa power meter.  The same
> thing does not happen with my FT-1000-MP.  The problem seems to be that
the
> SWR will not come down enough on 10 for full output on the Orion but the
MP
> can match it.  The problem with the HF6-V may be that I had to replace the
> top section of tubing with another longer piece of tubing and it does not
> tune as well on 10 meters.  I have concluded that the Orion antenna tuner
> just did not have enough range on 10 meters.  When I put the amplifier on
> line, the problem goes away.  The good news (and the bad news) is that
there
> is now seldom anything on 10 worth chasing anyway.
>
> 73,
>
> Dennis, K2SX
>
> -----Original Message-----
> From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
> On Behalf Of Steve Baron - KB3MM
> Sent: Tuesday, June 28, 2005 7:24 AM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] Ten Tec and Butternut HF6V Problem And Question
>
>
> Where and how are you measurung power?
>
> I used a V with a HF6V for many years always read full power.
>
> ----- Original Message ----- 
> From: <OTAKEBI at aol.com>
> To: <tentec at contesting.com>
> Sent: Tuesday, June 28, 2005 15:10
> Subject: [TenTec] Ten Tec and Butternut HF6V Problem And Question
>
>
> > I have a Butternut HF6V ground mounted vertical and on 10 meters and
> > 14 meters I get low output from both my Corsair II and OMNI V. On 10
> > meters my output on the Corsair II is about 60 watts. The antenna
> > shows a flat SWR If I place the tuner in line I get an increase of
> > about 15 watts after I adjust it for the same SWR.
> > I notice that I get low output on my Butternut Butterfly Beam.
> > About the same as on the vertical on 10 and 20.
> > However, when I switch to my G5RV I get full output from both rigs on 10
> and
> > 20.
> > I get about 95 watts out with a flat SWR going through the tuner.
> > Anyone on the list had this problem come up with the Butternuts and
> > Ten
> Tecs?
> > I don't see what could be cutting back the power especially on the
> > corsair II which does not have foldback protection. Thanks,
> > Dan/N4VET
> > _______________________________________________
> > TenTec mailing list
> > TenTec at contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>




More information about the TenTec mailing list