[TenTec] Model 544 TX/RX changeover problem redux

Adam N. adam2 at n4ekv.com
Tue May 24 15:26:12 EDT 2005


I have a nice Model 544 that has developed a transmit/receive changeover
problem that I need some assistance diagnosing.

All was working FB in QSO on 75m LSB when I unkeyed the mic and the
S-meter went near full scale with RX sigs very muted.  Powering off/on
the radio fixed the problem until I keyed up again, and then the problem
reoccurred.

I swapped out the main T/R reed relay with a new one from Ten-Tec.  I
also DeOxit'ed the T/R-RX antenna switch on the rear (thanks Ed/w4wvw).

Yet the problem persists on an intermittent basis.


73,

Adam N.
N4EKV
Lafayette, CA
www.n4ekv.com




More information about the TenTec mailing list