[TenTec] Paragon

[B. Lee Cornwell]

Hello Charles - Slide the rubber part of the tuning knob off - This 
exposes 2 set screws that must be removed with an allen wrench - remove 
the knob and look at the back - It becomes self-explanatory - Basically 
you hold the skirt of the knob while turning the main knob - this 
changes the drag placed against the panel - a quick shot of "tri-flow" 
may be needed on the encoder shaft
73
Lee K2BLC

Charles Nagel wrote:

>Is there a way to do it? Please advise me on-list.
>
>Thanks,
>
>Charles, K0CW
>
>-----Original Message-----
>From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
>On Behalf Of Jim G
>Sent: Saturday, October 29, 2005 10:57 PM
>To: Discussion of Ten-Tec Equipment
>Subject: [TenTec] Paragon
>
>Need some help on how to decrease the tension on the tuning dial.  Please
>reply off-list to longpond at downeast.net.  Jim K1QCF
>_______________________________________________
>TenTec mailing list
>TenTec at contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>_______________________________________________
>TenTec mailing list
>TenTec at contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>  
>

-- 
B. Lee Cornwell
http://home.earthlink.net/~k2blc/index.html