[TenTec] [Orion] [orion565] new firmware
Rick Williams
rick.williams at telus.net
Fri Apr 28 19:27:50 EDT 2006
Barry I just retried AM (100 watts into a dummy load) and MON function and I
cannot duplicate the problem you have report?
The MON worked on AM and came back to receive just fine? When I put the rig
back on an antenna the CW QSO I was listening to was still there. O1 and
version 2.056.
Not sure what's going on?
73,
Rick
VE7TK
Website: http://www3.telus.net/ve7tk
----------
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Subject: Re: [TenTec] [Orion] [orion565] new firmware
From: "Barry Gross"
Date: Fri, 28 Apr 2006 21:53:24 +0000
List-post: <mailto:tentec at contesting.com>
On 4/28/06, Grant Youngman <nq5t at comcast.net> wrote:
>
> I rechecked it after doing the usual resets, and it still doesn't work, so
> it's a fair assumption that it's broken in 2.03x, although interestingly I
> saw a post that said it works ok in 2.056.
I just checked the AM monitor on the O1 v2.056. Good news is that the
monitor functions fine when you first go into AM transmit. Bad news is that
when you release transmit, the receiver goes deaf and required a power
on/off cycle to bring it back.
73, Barry N1EU
More information about the TenTec
mailing list